AMX AVB-RX-DGX-SC Fiber-DVI, Инструкция по эксплуатации

Страница: 59 / 79

EDID Programmer
55 DGX Transmitters & Receivers Instruction Manual
Writing EDID Data to the TX
DGX HD-15 TX
The instructions that follow cover the situation in which the EDID Programmer is used to write EDID
information to the EDID chip for the Video Input connector on a previously unprogrammed
DGX HD-15 TX using an HD-15 cable.
DGX DVI TX
The instructions that follow can be adapted to cover the situation in which the EDID Programmer is used
to write EDID information to the EDID chip for the Video Input connector on a previously
unprogrammed DGX DVI TX. Use a DVI cable instead of an HD-15 cable. A DVI to HD-15 adapter
may be necessary depending on the PC (see “Using Cable Adapters” on page 53).
Note:
If the system contains an RX, the RX does not need to be connected, powered up or placed in
a specific Scaling option during the following process.
To write EDID data to the EDID chip on the TX:
1. Connect the HD-15 video cable (if necessary, use a cable adapter; see page 53) to the PC using the
PC’s spare monitor port.
2. Connect the open end of the HD-15 cable to the Video Input connector (HD-15) on the TX.
3.
Apply power to the TX.
4.
Flip the TX EDID switch up to the W (write enable) setting. (The EDID LED on the front of the TX
illuminates solid green.)
5. If not already open, open the EDID Programmer on the PC (for an illustration of the interface,
see page 54).
6.
For Target Device, select the Accessory Module option.
7. Save the TX’s EDID default as a backup (assumes the TX has no previous EDID programming) .

Click the Refresh Display List button

Select the device.

Click the Read button.

Click the Save button (select location, enter file name, and click Save).
8.
Click the Open button to select the .edid file to be written to the Video Input connector on the TX.
9. Click the Write button to write the EDID information to the Video Input connector.
10. Flip the TX EDID switch down to the WP (write protect) setting. (The EDID LED on the front of
the TX turns off.)
11.
Disconnect the HD-15 cable from the PC and from the TX.
Note:
Depending on the equipment used, conversion of the data from analog to digital or from digital
to analog may be necessary (click the conversion button before writing the EDID to the input).
FIG. 38 Flip EDID switch to W