4-5
Routine Maintenance
Service and Maintenance Procedures
129359-452, Volume 1
4.6.2
Install Chamber Door Gasket (See Figures 4-3 and 4-4)
SMALL STERILIZERS
1. Remove old gasket and clean groove. The replacement gasket is sized to
provide a
tight fit
.
2. Clean replacement gasket with a damp cloth and mark gasket at four
equidistant points to represent corners.
3. Press gasket into the groove at the four corners
a short section at a time
without stretching it while doing so.
• Should gasket appear too long ...
DO NOT CUT IT
... start over again,
compressing short sections into groove, until entire length is inserted.
•
NEVER use sharp tools to push gasket into groove.
4. Spray the sealing surface of the door frame with Fluorocarbon Spray
(P-752870-091; available from your local STERIS representative) to prevent
gasket from sticking.
MEDIUM STERILIZERS
1. Remove gasket bars and old gasket from door.
2. Clean door surface and gasket surface with STERIS Pry Cleaner. Make
certain that surfaces are free of foreign matter and excess cleaner.
3. Clean replacement gasket with a damp cloth and clean threads of the
gasket bar screw holes.
4. Replace gasket bars; leave bars loose enough to allow gasket to be
inserted.
5. Insert new gasket under gasket bars and tighten gasket bar retaining
screws just enough to hold the gasket in place.
•
Do not compress the gasket to any great extent in any one area.
6. Tighten gasket bars alternately until almost snug.
7. When gasket appears firmly seated under gasket bars and is flat on the
door, tighten gasket bar retaining screws until snug. (Always ensure that
screw heads are below surface of gasket bar.)
8. Spray the sealing surface of the door frame with Fluorocarbon Spray
(P-752870-091; available from your local STERIS representative) to prevent
gasket from sticking.
Figure 4-3. Install Door
Gasket – Small Sterilizers
Figure 4-4. Intall Door Gasket – Medium Sterilizers
Содержание EAGLE SERIES 3011
Страница 3: ...Intentionally Blank Page ...
