3-3
Service Adjustments and Special Features
Service and Maintenance Procedures
129359-452, Volume 1
NOTE: When Access Code function is enabled, the following message is
displayed every time the CHANGE VALUES touch pad is pressed (even if no
cycles are locked-out):
DO YOU KNOW ACCESS CODE?
NO
(NO will be blinking on and off.)
Press CHANGE VALUES touch pad
while “NO” is blinking
to automatically
advance control to first cycle which is not locked-out and cycle and cycle
values may be changed per Paragraph 3.3 of VOLUMES 2 or 3 of this manual.
3. Press VALUES “UP” direction arrow touch pad to change “NO” to “YES” and
press CHANGE VALUES touch pad
while “YES” is blinking
to advance
control to the following display message:
ENTER ACCESS CODE
CODE IS 0000
(Cursor position [first digit] will be blinking on and off.)
4. Enter access code as follows:
a. Press VALUES “UP” direction arrow touch pad the number of times equal
to the first digit.
b. Press CURSOR “RIGHT” direction arrow touch pad to move cursor to the
second digit.
c. Press VALUES “UP” direction arrow touch pad the number of times equal
to the second digit.
d. Press CURSOR “RIGHT” direction arrow touch pad to move cursor to the
third digit.
e. Press VALUES “UP” direction arrow touch pad the number of times equal
to the third digit.
f. Press CURSOR “RIGHT” direction arrow touch pad to move cursor to the
fourth digit.
g. Press VALUES “UP” direction arrow touch pad the number of times equal
to the fourth digit.
h. Press CHANGE VALUES touch pad to input the entered access code.
• If
incorrect
access code is entered, control will advance to first cycle
which is not locked-out and cycle and cycle values may be changed per
Paragraph 3.3 or 3.5 of VOLUMES 2 or 3, STERILIZER OPERATING
PROCEDURES. If all four cycles are locked out, control will advance to
CHANGE TIME AND DATE display. Press SAVE VALUES touch pad to
advance control to READY mode, then repeat the procedure and enter
correct
access code.
. . . or . . .
Figure 3-1. Turn Power On
Содержание EAGLE SERIES 3011
Страница 3: ...Intentionally Blank Page ...
