Ammann ASC 200 Series, Руководство по эксплуатации

Страница: 95 / 198

95 ASC110/ASC130/ASC150/ASC200/ASC250
OPERATING INSTRUCTIONS
2.7.7. Troubleshooting according to
flashing codes
•
In case of engine fault, either stop engine red signal
lamp 18 or engine warning yellow lamp 19 will light up.
•••••
Before troubleshooting stop the engine and turn the
ignition key 9 to ”I” position.
•
Press button 16 to activate error code. The lighting
signal lamp will start flashing in the code correspond-
ing to the defect and it repeat twice in the same
sequence.
•
Press button 17 to move to the next error. You can
search for error codes stored in ECM index using
symbols of switch 17: upper symbol forward or bottom
symbol backward.
Example of flashing error code
Flashing code consists of three digits.
Example: code 123 signal lamp
Yellow lamp 19 will flash, red lamp 18 will flash the code
after 1-2 sec.
Number 1: red will flash once, then pauses for 1-2 sec.
Number 2: red will flash twice, then pauses for 1-2 sec.
Number 3: red will flash thrice.
When the number has finished flashing in red, a yellow
lamp will appear again. The three – digit code will repeat
in the same sequence. Press button 17 to move to the next
error.
NOTE: If only one defect is identified, its error code will be
signalled repeatedly even if you press switch 17 in either
direction.
After the signal lamp 18 goes
on, stop operation and engine
while keeping safety at work!
Do not start the engine before
the defect has been repaired!
! NOTE !
If signal lamp 19 lights up, repair the
defect as soon as possible!