Ammann ASC 200 Series, Руководство по эксплуатации

Страница: 65 / 198

65 ASC110/ASC130/ASC150/ASC200/ASC250
OPERATING INSTRUCTIONS
Steering wheel 7
Use the steering wheel to steer the machine.
! NOTE !
When driving without vibration, set
optimum speed (e.g. 1800 rpm) to ensure
safe steering.
Engine speed selector 8
Use this control to decrease combustion engine speed.
Note
The switch 8 decrease from max to min engine speed.
Switch box 9
There are three positions: ”0”, ”I” and ”II”. In ”0” position,
all appliances of fuses F1, F2 and F7 are connected; in ”I”
position, remaining appliances are connected; ”II” spring
position is used for starting the machine. Stop the ma-
chine by turning the key to ”0” position; the key can then
be removed.
Note
The key of switch box is used for door of cabine and servis
door under cabine and tools box.
! NOTE !
Remove the key from the switch box when
leaving the machine!
In cabinless machines, protect the ignition
box from water and dirt by folding the box
cover after having removed the key.
Hydraulic oil thermometer 10
Indicates the hydraulic oil temperature during operation.
! NOTE ! Top limit is 90 °C for oils of
viscosity grades HV 68 and HV 100. 50 -
60 °C (122 - 140 °F) is the optimum work-
ing temperature.
Using other viscosity grade oils:
Oil viscosity
Max. allowed oil temperature
HV 46 80 °C
HV 32 70 °C
Fuel gauge 11
Indicates the level of fuel in fuel tank.
! NOTE !
Check the gauge regularly during opera-
tion.
Revolution counter 12
Indicates engine revolutions per minute.
Hourmeter 13
Indicates hours of running engine. The counter starts
counting (adding) at starting the engine.
Note
Counting hours does not depend on engine speed.
Connector 14
Use the connector to connect ECM (Electronic Control
Module) and diagnostics trouble.
Note
ECM processes engine function data and controls the
engine. Sensors pick up information on engine function
and malfunctions and transfer it to ECM. The control
module analyses input and returns commands for the
engine to function properly.
Malfunctions and other data is identified and stored in
ECM memory. This data will be transferred after connect-
ing a service device (notebook) to connector 14.