Ammann ASC 200 Series, Руководство по эксплуатации

Страница: 86 / 198

86 ASC110/ASC130/ASC150/ASC200/ASC250
2.7. Controlling and operation of the machine
2.7.1. Starting the engine
Start-up procedure:
•
Turn on battery disconnecter.
•
Turn on the engine idle switch 15.
•
Make sure that the emergency brake “STOP” button 5
is not pressed down.
•
Switch over the ignition box key 9 to the “l” position –
the brake indicator lamp 23, charging indicator lamp
22, neutral indicator lamp 24, and WTS indicator lamp
21 – engine heating light up.
•
The engine diagnostics indicator lamps 18 and 19
light up and go out after 4 seconds.
•
Wait until the WTS indicator lamp 21 goes out. Switch
over the ignition box key to the “ll” position and start the
engine (keep the key in the “ll” position only until the
engine starts).
•
The charging signal lamp must go off after starting up
the engine.
WARNING!
Do not start longer than 30 seconds. Wait
for 2 minutes before next starting.
Repeat starting procedure 3 times at
most; then detect the cause in fuel sys-
tem. Missing smoke in the exhaust pipe
indicates failure in fuel supply to the
engine.
After starting up, check correct engine
operation by indicators.
Do not run up the engine rapidly; let the
engine run at idle speed for 3 to 5 min-
utes to stabilize pressure in the engine
and to have bearings lubricate.
Do not let the engine run at idle speed
for longer then 10 minutes to avoid
engine damage.
Do not load the engine with full power
until the temperature of cooling liquid
reaches 60 °C (140 °F).
Starting will be blocked at the following
instances:
If the engine iddle switch 15 is
switched off.
If the brake switch 4 is not switched
on.
STOP button 5 is pressed
Control 1 is not in neutral.
If the operator is not siting on the
seat.
Blow horn before starting the
engine to check that nobody
is endangered by starting the
engine!