Ammann ASC 200 Series, Руководство по эксплуатации

Страница: 67 / 198

67 ASC110/ASC130/ASC150/ASC200/ASC250
OPERATING INSTRUCTIONS
Engine idling switch 15
Use the switch to turn on engine idling with an engine
start. Signal lamp in the switch will light up upon activat-
ing.
Engine diagnostics switch 16
In case of a malfunction of the engine, clutch the diagnos-
tics switch 16 to identify the defect on the basis of flashing
code on signal lamp 18.
Note
Signal lamp 18 or 19 will go on in case of an engine
malfunction, depending on severity of the defect. After
activating switch 16, the will start flashing the code of the
first defect see chapter 2.7.7.
If both pilot lamps indicating defects (yellow – 19 and red
– 18) go on after pressing the switch when the ignition box
is on that means no defects have been identified by
engine ECM.
Troubleshooting switch 17 (idle speed op-
tion)
The switch is in the middle position.
Turn it continuously any direction (+ forward or
- backward) to find defects according to flash-
ing codes of signal lamps 18 or 19.
Note
In the event that the engine idle switch 15 is in the position
of idle speed and the engine diagnostics switch 16 is
switched off, it is possible to select, using the switch 17,
an idle engine speed within the range of 650 to 1,200 RPM
by repeated switching in the switch 17. By switching in the
upper half of the switch 17, the idle engine speed is
reduced. By switching in the lower half of the switch 17,
the idle engine speed is increased. The selected speed
is stored into the memory of the engine computer and it
is set to the last pre-selected value with a new start. Within
the factory setting, the idle engine speed is set to 850 RPM
and the machine parameters are adjusted at this setting.