American Changer AC2002, Руководство по эксплуатации

Страница: 20 / 25

20
SECTION B
TROUBLESHOOTING INFORMATION
NOTE: Before starting this procedure ensure the changer is plugged in, the ON/OFF switch is on, the hoppers are
full of coins, and all wire harnesses are connected securely and correctly.
The wires exiting the red connectors should point away from the board!!
TECHNICAL FLOW DIAGRAM SERIES
IS THE
"EMPTY" LED
"ON"?
Yes
PRESS AND HOLD THE
"DUMP BUTTON " ON
THE MAIN LOGIC
BOARD. WHAT
NUMBER(S) ARE
DISPLAYED?
#02
#01
#04
#10
Hopper Exit window
is blocked. Please
do the following.
1. Remove all the
coins.
2. Take off the
Track side cover of
the hopper.
3. Remove the
object from the
window.
4. Reassemble the
hopper.
The hopper has a
low coin shut down.
Please do the
following:
1. Ensure the
hopper is full of
coins. Turn off the
machine, wait 5 sec.
then turn it back on
again.
2 Clean the 3 gold
plates at the bottom
of the hopper where
the coins are poured
in with a scotch
bright pad or emery
cloth.
3. Check continuity
of the wires from
the gold plates back
to the logic board.
The hopper is
jammed.
The hopper
overpaid by 2
to many coins
and was shut
down. Replace
the hopper or
the hopper
harness.
NO
Is the GREEN
LED on the
main logic
board on?
Yes
NO
Is the On/
Off (I/O)
switch on?
(I pressed
down?)
Yes
Is the
120VAC plug
pushed into
the bottom of
the logic
board and into
the wall?
Yes
Using a
meter check
the 2-amp
fuse. Is it
good good?
Yes
NO
Check the 120VAC
wall breaker.
Replace the FUSE
then the logic board.
Will the CoinCo bill
acceptor attempt to
pull bills in at all?
Are the RED bill
meter numbers lit
on the main logic
display?
NO
Yes
NO
YES
It appears as if your CoinCo is
dirty or the belts are worn. Please
try the following:
1. Go to Page 7 and perform the
cleaning procedure.
2. If that is unsuccessful inspect
the plastic lower housing for deep
scratches or VANDALISM.
3. If the CoinCo has accepted over
50,000 bills it could need new
belts.
The CoinCo is
flashing an
"ERROR CODE".
Please go to the
CoinCo Error code
section of this
manual. Page 8.
The bill acceptor
is flashing an
“ERROR CODE.”
See the Trouble-
shooting Guide in
this manual for
error codes.
Will the bill
acceptor attempt
to pull bills in at
all?
It appears as if your bill acceptor is dirty or
the belts are worn. Please try the following:
1. Perform the cleaning procedure described
in the cleaning kit instructions included in
your information packet.
2.
If that is unsuccessful, inspect the plastic
lower housing for deep scratches or
VANDALISM.
3.
If the bill acceptor has accepted over
50,000 bills, it could need new belts.