American Changer AC2002, Руководство по эксплуатации

Страница: 5 / 25

5
SECTION A
SETUP & INSTALLATION
Setup
Inspect for any connectors or components that may have been dislodged during shipping. The
lock and keys for your changer will be inside the manila envelope along with this manual and
other pertinent information. To install the lock, insert the cylinder into the hole in the middle
of the T-handle and push until it stops. Turn the key until you hear it “snap." Turn the key
counterclockwise ¼ turn and remove the keys.
NOTE: The only way to get a duplicate set of keys made is to save the tag
that comes between the keys. This ID # starts with “AC or ACC ####.”
CELLULAR WIRELESS CREDIT CARD SYSTEM (optional)
This feature is an optional add-on for most American Changer models. A separate
maintenance manual is included in your packet. You
MUST call American Changer technical
support at (888) 741-9840 for setup and operating instructions. Prior to startup in the
wireless mode, the machine will operate and validate cash transactions only.
Mounting the AC2002/2002.1 to a Wall
IF YOU ARE UNSURE IN ANY WAY IN PROCEEDING WITH THE FOLLOWING STEPS,
PLEASE HIRE A LICENSED ELECTRICIAN TO MOUNT YOUR CHANGER FOR YOU!
1.
Disconnect any and all AC power going to the changer. (Unplug AC line cord from the
Power Module Board and from the wall.)
2.
Slide the hoppers out of the cabinet.
3.
Note: You will need to verify with the building code to see if it is allowable to plug the
changer into a 3-prong grounded outlet. If it is not, there must be 120VAC run through
conduit or other means to meet local codes to the changer. If it is not required, proceed
to step #6.
4.
Let the electrician run the conduit, install the new breaker, wire and help decide how the
wiring will enter the changer (from the back or the bottom). This will affect the mounting
location.
5.
After the conduit has been installed, proceed with the mounting.
6.
Locate the 4 punch-outs on the back or side wall of the changer. Using a screwdriver and
hammer, remove the punch-outs by striking them from the inside of the changer.
7.
Find an appropriate wall into which to bolt the changer. The wall should have studs or be
constructed of concrete.
8.
NOTE: HANGING THE CHANGER FROM FEWER THAN THE HOLES PROVIDED MAY
BE DANGEROUS. EACH HOLE NEEDS A BOLT THROUGH IT TO SECURELY MOUNT
THE CHANGER TO THE WALL. MOUNTING THE CHANGER IN ANY OTHER WAY
MAY RESULT IN THE CHANGER BEING TORN FROM OR FALLING FROM THE WALL,
RESULTING IN PERSONAL OR CUSTOMER INJURY ALONG WITH ELECTRICAL
SHOCK.