Alutech CU-TR230, Инструкция по установке и эксплуатации

Страница: 110 / 138

CONTROL UNITS СU-TR230 / СU-TR400
108 108
SETTINGS
MENU SETTING DESCRIPTION VALUES
FACTORY
VALUE
P8 F4
Lighting operation time after the command
of the radio control LIGHTING ON. The operat-
ing time of the lighting lamp is set in the case
of recording a remote control for lighting con-
trol (LIGHTING command, Table 4)
no — lighting lamp
does not turn off
according to time
(it turns off only at
the command of the
remote control)
01, 02 … 99:
01 — 1 min
99 — 99 min
no.
F7
Operating time LOAD № 1 after the command
of the remote control LOAD № 1 ENABLE. The
operating time of the outputs of the connectors
7 – 9 (value 13 , Table 14) is configured in the case
of recording the remote for load control (LOAD
command № 1, Table 4)
no — load does not
turn off according
to time (it turns
off only at the
command of the
remote control)
01 , 02 … 99:
01 — 1 min
99 — 99 min
no.
F8
Operating time LOAD № 2 after the command
of the remote control LOAD № 2 ENABLE. The
operating time of the outputs of the connectors
7 – 9 (value 14 , Table 14) is configured in the case
of recording the remote for load control (LOAD
command № 2, Table 4)
no
— load does not
turn off according
to time (it turns
off only at the
command of the
remote control)
01 , 02 … 99:
01 — 1 min
99 — 99 min
no.
P0
F0
Reset to factory settings. See section ‘6.4. Reset to factory settings’
F1 Cycle counter. See section ‘6.5. Cycle counter data’
Table 14 describes the operating modes of the outputs of connectors 7 – 9 ( Figure 8 / Figure 9).
When setting the value (
P3
–
F4
…
F6
), the outputs of the connectors (relay contacts of the control
unit) will operate in accordance with the specified logic. The figure shows the normal status of
the outputs (relay contacts of the control unit).
JX.3
JX.2
JX.1
7-9
NO
NC
COM
NO — normally open contact
NC
— normally closed contact