Alutech CU-TR230, Инструкция по установке и эксплуатации

Страница: 93 / 138

CONTROL UNITS СU-TR230 / СU-TR400
91 91
ELECTRICAL CONNECTIONS
OPTION 2.
Installation with four external fasteners ( Figure 3). On the base of the control unit
body, use screws 4 ( Figure 1) to install at the required mounting angle 3 ( Figure 1). Then mark
the fixing points on the mounting surface and fix the unit.
5. ELECTRICAL CONNECTIONS
Y
ATTENTION!
For electrical connections make sure that the mains power is disconnected (cir-
cuit breaker of the mains power is off)!
Follow electrical safety regulations!
Y
Use a puller to remove the connectors. Gently pull with the puller by the connector ( Figure 6),
if necessary, in several locations along the length of the connector.
The door control buttons and the display window are located on the unit body cover ( Figure 7).
The buttons are connected to the electronic module of the unit by the manufacturer.
5.1 NETWORK AND ELECTRIC DRIVE CONNECTIONS
The network connection is performed to connector 1 of the unit (CU-TR230 — Figure 8,
CU-TR400 — Figure 9). L is phase (phases), N is neutral. Protective earth is connected to connector 2 .
Y
When connecting to the network, there should be provided a device disconnecting all poles
from the network (for instance, automatic circuit breaker), which ensures full disconnection
under conditions of over-voltage category III. The device should be installed in accordance
with Electrical Installations Code and located at easily accessible place, at convenient and safe
height (1.5–1.9 m).
The electric drive is connected to connector 10 .
The connection of connectors 4 and 12 is performed by the manufacturer
• Network and electric drive TP series (230 V ~) connection to the CU-TR230 control unit is
presented in Figure 10.
• Network and electric drive TP series (400 V 3~) connection to the CU-TR400 control unit is
presented in Figure 11.
Y
When connecting the electric drive to the control unit, first read the section on electrical con-
nections of the drive manual. Identify the required cable and the wire marking of cable sup-
plied with the drive.
5.2 CONNECTION OF SWITCHES / DRIVE ENCODER
• Connection a driver TR series with mechanical switches is shown in Figure 12.
Limit switches ( B ) of drive are connected to OP.L and CL.L contacts. Function switches ( A )
of drive are connected to
5.L
and
P.L
contacts, which must be used when switching on in
the unit menu the settings P5 – F7 and P5 – F1 ( Table 13), respectively. Сontact P.L is not used
in the CU-TR400 control unit!
Y
Make sure that connector
18
is installed with a crossbar (is included in complete kit).
If there is no connector with a crossbar, connect a crossbar between the IN_S and O_S
contacts of connector 16 . When connecting the electric drive to the control unit, first
read the section on electrical connections of the drive manual. Identify the required
cable and the wire marking of cable supplied with the drive