Alutech CU-TR230, Инструкция по установке и эксплуатации

Страница: 114 / 138

CONTROL UNITS СU-TR230 / СU-TR400
112 112
SETTINGS
6.6 INPUT А OPERATION (SETTING P7–F5–AL)
If the value АL is selected in setting P7 – F5 , the control command of the connection input
А ( Table 2) will lead to doors movement to the previously set intermediate position of opening
(for example, 2.5 m) or to the complete doors opening. When stopping at the previously set re-
quired intermediate position, the unit will display inscription АL .
Y
ATTENTION! Only during holding (closing) input А all other control commands are ignored and
will not be executed (block control inputs, radio remote controls, buttons, etc.). The connected
safety devices during opening (input
S
, Table 2) remain active (safety commands are executed).
Pressing the button of the control unit (3, fig. 7) will stop the movement of doors; after re-
leasing the button, the actuation (closure) of input ‘
А
’ will be executed. When the
P7
–
F5
–
AL
set-
ting is enabled, the P5 – F1 setting (obstacle detection at opening) is disabled (does not operate).
SETTING THE INTERMEDIATE POSITION OF THE DOORS OPENING
WHEN SELECTING P7–F5–AL
1. Drive with switches (P1–F0–01)
:
It is necessary to connect to the control unit ( fig. 24) and set the free cam / switch of the
TR
se-
ries drive (for example, cam E , or consequently switch S5 ) to operate in the required intermedi-
ate position. Refer to the drive manual for the description of cams and switches location in the
drive, as well as adjusting the cam position.
Y
ATTENTION!
Beforehand, it is necessary to change the wire on the switch from the
NC
contact
to the NO contact ( fig . 24)!
Y
ATTENTION! If the cam / switch of the drive is not connected and set, then by the command of
input control
A
doors will be fully opened.
Y
ATTENTION! If doors at the moment of input A actuation was higher than the set intermediate
position, then doors will be fully opened.
2. Drive with encoder (P1–F0–02):
After turning on the P7 – F5 – АL setting, the P1 – F7 setting ( Table 13) will be used to set the in-
termediate doors opening for input control
A
.
After entering the
P1
–
F7
setting using or button, set the doors to the required
position and press the button to confirm the set position. The display shows the inscrip-
tion AL with a dot ( AL. ).
Y
ATTENTION! If the P1 – F7 setting is not activated (not set), then by the command of input con-
trol
A
the doors will be fully opened.