Altigen Altiware OE 4.5, Руководство по системному администрированию и установке, Страница: 15 / 455

xiv AltiWare OE System Installation & Administration Manual
FCC Requirements
1. The Federal Communications Commission (FCC) has established
Rules which permit this device to be directly connected to the telephone
network. Standardized jacks are used for these connections. This
equipment should not be used on party lines or coin phones.
2. If this device is malfunctioning, it may also be causing harm to the
telephone network; this device should be disconnected until the source
of the problem can be determined and until repair has been made. If this
is not done, the telephone company may temporarily disconnect
service.
3. The telephone company may make changes in its technical operations
and procedures; if such changes affect the compatibility or use of this
device, the telephone company is required to give adequate notice of
the changes. You will be advised of your rights to file a complaint with
the FCC.
4. If the telephone company requests information on what equipment is
connected to their lines, inform them of:
a. The telephone number to which this unit is connected.
b. The ringer equivalence number. [0.0B]
c. The USOC jack required. [RJ11C]
d. The FCC Registration Number. [see label on board]
e. Industry Canada (Industrie Canada) Certification Number.
[see label on board]
Items (b) and (d) are indicated on the label. The Ringer Equivalence
Number (REN) is used to determine how many devices can be connected
to your telephone line. In most areas, the sum of the RENs of all devices on
any one line should not exceed five (5.0). If too many devices are attached,
they may not ring properly.
Service Requirements
In the event of equipment malfunction, all repairs should be performed by
our Company or an authorized agent. It is the responsibility of users
requiring service to report the need for service to AltiGen or to one of our
authorized agents. Service can be obtained at your Authorized AltiGen
Dealer.