D000161-00 Rev. C
34
Figure 29 shows the slat has been pushed down and
rotated outwards to capture the top of the slat under the
metal tabs.
3. Take the black plastic sliders and slide one
under each metal tab (Figure 30). Push them far
enough so the metal tab rests on the flat
surface of the slider. These can be quite tight so
you might need the plastic tool and a mallet to
tap them into place. Once again, be careful not
to slip and cut the enclosure.
4. Repeat steps 1-3 for each side of the enclosure
that you have removed.
5. It is preferable that you perform any
maintenance where you have to remove the
enclosure at the end of the day. This will give
the foam that forms the airtight seal between
the enclosure and base a chance to expand and reseal.
Figure 29
Figure 30
