D000161-00 Rev. C
45
APPENDIX E: FEATURE CHANGES
Below is a table of feature changes that you may encounter if upgrading from a previous model
of the Pro 200 to the Pro 200 Plus.
Calibration Failure
If unit will fail during calibration if it cannot unweight the user
below 90% BW
and/or
if it cannot gather more than 5 calibration
points.
(Both requirements are needed. On average 15-20 points are taken
during calibration).
Emergency Stop
If you pull the e-stop magnet, the treadmill will maintain pressure.
This is meant to protect the user, and prevent the bag from being
dumped.
Error Code: Calibration “Unable to reach target weight”
Click “restart”
black screen command prompt
click the “x” at
the top right hand corner
brought back to home screen to begin
new session
Error Code: Incline
“Unable to reach target incline”
Click “restart”
black screen command prompt
click the “x” at
the top right hand corner
brought back to home screen to begin
new session
Error Code: Speed
“Unable to reach target speed”
Click “restart”
black screen command prompt
click the “x” at
the top right hand corner
brought back to home screen to begin
new session
Facility Settings Code:
5900
Input facility information, adjust camera settings, reset cameras
Facility Settings Code:
5369
Adjust treadmill belt creep
Shut Down
No soft shut down button. Instruct users to push hard button on
monitor.
Speed change
Treadmill will slow to a stop before switching directions.
There is no verification message (ex: Click “ok” to go in reverse)
on-screen.
Unweighting Time
Calibration times out after 90 seconds.
Unweighting Limits
Example: If user can’t be calibrated below 40% BW during
calibration, they will not be able to go below 40% during session.
Previous software showed they were going lower, but they weren’t
actually being unweighted beyond 40%. This is a more accurate
reading of what body weight % the user is at.
Video Display
Video monitor must be turned on
before
powering up Pro 200. If
not, the unit will not detect the second monitor and no video will be
displayed.
Workout Programmer
No timing countdown between sessions.
Green progress bar shown above session data. This indicates
duration until interval complete.
