D000161-00 Rev. C
29
Enclosure and Frame Cleaning and Disinfection
Surfaces of the Anti-Gravity Treadmill fabric shell and tubular framework can be wiped with 10%
bleach solution or other detergents/disinfectants that are compatible with urethane coatings and
epoxy based paint films and meet the CDC’s guidelines for disinfection. Do not soak surfaces
to the point that the bleach solution begins to run. Regular cleaning and wiping of the surfaces
after each use is recommended. Following exposure to infectious agents, clean the surfaces of
the machine in accordance with CDC guidelines or consult AlterG Inc. General Cleaning and
Inspection Periodic cleaning and inspection will help lengthen the life of your machine and keep
it looking good. The biggest contributor to the failure of the machine will be dirt and debris
accumulation inside the treadmill. To prevent this, ensure users always wear clean shoes while
they exercise. Since it is a sealed system, the presence of dirt and debris greatly reduces the
longevity of the product.
Keeping the system clean will also make it easier to spot any problems that might not otherwise
be found until it is too late. Below is a general guideline on cleaning and maintenance intervals.
If the Anti-Gravity Treadmill is in a dirty environment or under heavy use, cleaning and
inspection intervals should occur more frequently. Do not use abrasive brushes or cleaners as
they will mar and scratch the paint and plastic surfaces. Also, do not soak any surface with a
liquid, as the sensitive electronics can be damaged or pose an electrical hazard.
Daily:
1. Inspect and remove any loose debris from the interior of the enclosure.
2. Check for abnormal operation.
a. Ensure that there are no unusual performance characteristics such as:
i. i. Unusual sounds (from the treadmill, air blower, or enclosure such as
hissing of air leaks.)
ii. Unusual sights, or smells that appear out of the ordinary.
iii. Any operational characteristics that have changed such as reduced
speed of treadmill or erratic or low enclosure pressure. (Note that low
enclosure pressure can be caused by a miss-calibration, so ensure that
you have properly followed the calibration steps before you determine
there is a pressurization problem.)
Weekly:
1. Check overall condition of the treadmill.
2. Inspect the height adjusters used to position the oval support frame for wear or damage.
3. Inspect the red safety latches for proper function and unusual wear.
4. Inspect the enclosure for tears or leaks.
5. Wipe down exterior surfaces with a damp cloth. This will help prevent the windows from
yellowing.
6. Wipe the enclosure and monitor when needed, using a micro-fiber cloth to avoid
scratches. (Note: Wipe the monitor when the machine is off to avoid accidental touches
from pressing the screen.)
7. Check for loose wires and cables.
8. Vacuum the interior of the enclosure through the access hole in the top of the enclosure.
You can position the oval support frame in the highest position and crawl inside like a
tent to get better access.
9. Vacuum around the base of the treadmill.
10. Check shorts for rips or holes.
Monthly:
