ALMAC MULTI-LOADER 6.0, Перевод оригинальной инструкции

Страница: 126 / 127

PAGE
126 ALMAC s.r.l.
4.6 S
TOPPING THE MACHINE
_______________________________________________________ 71
4.6.1 Normal stop ___________________________________________________________ 71
4.6.2 Emergency stop ________________________________________________________ 71
5 EMERGENCY PROCEDURES________________________________________________ 73
5.1 R
ECEPTION PROBLEMS WITH REMOTE CONTROL
_______________________________________ 73
5.2 T
RANSPORTING THE MACHINE IN AN EMERGENCY
______________________________________ 73
5.3 E
MERGENCY MOVEMENTS FROM HYDRAULIC BLOCK
_____________________________________ 73
6 MAINTENANCE _________________________________________________________ 74
6.1 G
ENERAL MAINTENANCE
_______________________________________________________ 74
6.1.1 Ordinary maintenance schedule table _____________________________________ 74
6.1.2 Checks before each use _________________________________________________ 76
6.2 M
AINTENANCE
: D
ETAILS
_______________________________________________________ 77
6.2.1 Checking and tightening screws, bolts, plug ring nuts ________________________ 77
6.2.2 Visual and structural inspection __________________________________________ 78
6.2.3 Damage to tubes and cables _____________________________________________ 78
6.2.4 Checking the hydraulic tank oil level and topping up if necessary ______________ 79
6.2.5 Hydraulic reservoir oil change ___________________________________________ 79
6.2.6 Checking the operation of the maximum pressure valves _____________________ 80
6.2.7 Hydraulic filter replacement ____________________________________________ 81
6.2.7.1 Suction filters replacement _________________________________________________ 82
6.2.7.2 Replacing the discharge filter _______________________________________________ 82
6.2.8 Traction batteries (Type:Lead Crystal) ____________________________________ 84
6.2.8.1 General warnings _________________________________________________________ 84
6.2.8.2 Maintenance _____________________________________________________________ 85
6.2.8.3 Recharging _______________________________________________________________ 86
6.2.8.4 Battery storage ___________________________________________________________ 86
6.2.9 Checking the operation of the frame angle sensor___________________________ 87
6.2.10 Verification of the chassis angle sensor function __________________________ 88
6.2.11 Checking the differential circuit breaker ________________________________ 89
6.2.12 Check the seal of the chassis balancing valves ____________________________ 90
6.2.13 Track inspection and tensioning _______________________________________ 102
6.2.14 Checking the tracks for wear _________________________________________ 104
6.2.15 Replacing the tracks ________________________________________________ 104
6.2.16 Track reduction gear oil level inspection _______________________________ 107
7 DEMOLITION _________________________________________________________ 108
7.1 M
ACHINE LIFE
_____________________________________________________________ 108
7.2 D
ECOMMISSIONING AND DEMOLITION
______________________________________________ 108