Alltech KEENAN MechFiber380, Руководство оператора

Страница: 20 / 73

KEENAN
MechFiber380 Operator’s Manual
Revision D02 09
th
Sept 2020
20
7.6 Operating the KEENAN MechFiber bale handler
Table 3: Loading the KEENAN MechFiber bale handler
LOADING THE KEENAN BALE HANDLER
GENERAL
• Park on level ground.
• Ensure variable feed control (VFC) door is closed.
• Do not start PTO when VFC-door is open.
LOADING AND MIXING SEQUENCE
• Set paddles running at
6
–8 RPM
for all bale types. Note: When chopping straw, higher
revs can be used.
• Load round bales to the centre of the unit with the flat end toward the top knife.
• Allow a minimum of 2 minutes for the bale to chop down before adding another.
CAUTION : Do not load more than one bale at a time.
• Stop PTO before moving to feed-out area.
• Mixing time will depend on the required chop length.
Below is a guide to the correct loading order. Consult your local InTouch
office/nutritionist for more guidance on the best loading order for your ingredients.
Order Feed ingredients Paddle RPM Tractor engine speed
1st Straw, hay
All at 6
–8 RPM
1,400
–1,600 RPM
2nd Water, liquid feeds
3rd Minerals, concentrates, protein
meals, pulps, cereal grains
4th Grass silage
5th Maize silage