Alltech KEENAN MechFiber380, Руководство оператора

Страница: 30 / 73

KEENAN
MechFiber380 Operator’s Manual
Revision D02 09
th
Sept 2020
30
Figure 15: Bale handler tine to top knife setting
4: Check that the operation of the creel, both up and down, is smooth and
unobstructed.
5: Check that the creel rubber is in place, is undamaged and is lowering and raising
with the creel.
Note: The creel rubber is fitted to prevent material from sitting on the top knife of the machine,
additionally preventing a build-up of material from getting under the creel and damaging it as
it is lowered. To prevent damage to this rubber, do not drop material on it from a height when
loading material onto bale handler arms
.
8.7 Shear bolt
The following are the recommended shear bolts to be used with the KEENAN
MechFiber380:
Table 5: Shear bolt specification
PTO speed range Shaft Shear bolt
Part no.
540 rpm T80 and V80 M12 x 70 x 5.6 705410
1000 rpm T60 and V60 M10 x 60 x 4.6 700235
CAUTION:
Failure to use the correct grade of shear bolt can result in overload failure of the
machine and will invalidate your warranty.
Add or remove shims as required