Alltech KEENAN MechFiber380, Руководство оператора

Страница: 16 / 73

KEENAN
MechFiber380 Operator’s Manual
Revision D02 09
th
Sept 2020
16
7.2 Hitch height adjustment
The KEENAN MechFiber380 hitch was designed to allow for various hitch height options
with the same components used. Hitch height is normally selected for the application and
set at the factory. However, if required, the hitch can be adjusted on-farm to level the
machine. Several options are shown below in Figures 5.1 and 5.2.
The main standard hitch assembly is a bolt-on assembly, and once the main setting is
completed at the factory, it may also be adjusted on-farm by moving the assembly up or
down within the bolt holes, or by turning the complete hitch over, as it is suitable to operate
facing either way.
Note:
1: A minimum of four M20 x 100 mm Grade 8.8 bolts must be used to secure the straight hitch eye and the
clevis hitch to the drawbar.
2: Care must be taken when adjusting the hitch height to ensure that there is adequate PTO clearance and
ground clearance below the stand
.
Figure 5.1: Standard hitch adjustment
Figure 5.2: Clevis hitch adjustment
82 mm range
Tyre and suspension deflection
Tyre and suspension deflection
Height adjustment available here
Clevis hitch eye