background image

02CHYTWR-V2

MADE IN GREAT BRITAIN

PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE

For Assistance Please 

Contact Customer Care on 

01636 880514

x2

Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

This building should be erected by 

two Adults.

For ease of assembly, it is advisable to 

pilot drill all screw holes and ensure 

all screw heads are countersunk. We 

recommend using a 2mm, 5mm and 

8mm drill bit.

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY 

- Check the pack and make sure you have all the parts listed. 

- When you are ready to start, make sure you have the right tools at hand 

(not supplied) including  a Phillips screwdriver, Utility knife, wood saw, and 

drill with 2mm, 5mm and 8mm bit.

- Ensure there is plenty of space and a clean dry area for assembly. 

- Make sure you have a suitable base ready to erect your building and is 

accessible all the way around to enable any maintenance to be carried out 

if needed. 

TIMBER

As with all natural materials, timber can be affected during various weather 

conditions. For the duration of heavy or extended periods of rain, swelling 

of the wood panels may occur. Warping of the wood may also occur during 

excessive dry spells due to an interior moisture loss. Unfortunately, these 

processes cannot be avoided but can be helped. It is suggested that the 

outdoor building is sprayed with water during extended periods of warm 

sunshine and sheltered as much as possible during rain or snow. 

Though this building is supplied pre painted it is recommended to treat the building 

annually using wood paint or preserveative which there are a variety of of colours 

and stains available.

Annual care and maintenance will ensure the longevity of your 

building.

Whilst all products manufactured are made to the highest standards of Safety and in the case of childrens products independently 

tested to EN71 level. We cannot accept responsibility for your safety whilst erecting or using this product. 

Mercia Garden Products Limited, Sutton On Trent, Newark, Nottinghamshire, NG23 

CONTENTS

CHECK ALL PARTS LISTED ARE IN THE KIT BEFORE ASSEMBLY

BASE DIMENSIONS

Length - cm

Width - cm

OVERALL DIMENSIONS

Length - cm

Width - cm

Height - 0cm

50mm Screw x 43 

40mm Screw x 25 

20mm Screw x 5

30mm Screw x 4

10mm Screw x 20

100mm Screw x35

2

1

3

4

5

6

7

8

9

10

11

12

13

14

WARNING: Only for domestic use

Not suitable for children under 36 month

To be used under direct supervision of an adult

Bunk Floor

44x58x1088mm x3

44x58x1870mm  x2

28x28x1170mm x2

27x58x1044mm

44x58x523mm  x4

27x58x400mm  x8

Ladder side Left

Ladder side Right

Ladder Step 27x95x476mm   x2

Slide

28x28x1057mm x2

Shiplap board 1200mm

Shiplap board 1112mm  x2

Содержание 02CHYTWR-V2






Отзывы: