2
Chapter 2
Initial Configuration
This Chapter covers the initial configuration of the ALL0274.
Requirements
•
Network cable. Use a standard 10/100BaseT network (UTP) cable with RJ45 connectors.
•
TCP/IP protocol must be installed on your PC.
•
To use the Wireless interface, your PC must be compliant with the IEEE802.11b or
IEEE802.11g specifications.
Procedure
1. Use the mode selector switch on the side on the ALL0274 to select "Config" mode.
2. Power up and wait for the Wireless LED to turn on. This indicates the ALL0274 is ready.
3. Establish a Wired or Wireless connection to the ALL0274 (a Wired connection is recom-
mended).
•
Wired
- connect a standard LAN cable from your PC's 10/100BaseT Ethernet port to
the Ethernet port on the ALL0274.
•
Wireless
- select the wireless network with the SSID
default
4. Start your Web browser.
5. In the "Location" or "Address" bar, enter the following:
config.ap
•
This will work only while in
Config
mode.
In AP mode, you cannot connect.
In Router mode, you must connect using the
Wireless LAN IP address
.
•
This may not work if using a wireless connection and your PC also has an active
10/100BaseT Ethernet connection.
6. You will be prompted for the username and password.
•
Enter
admin
for the user name.
•
Enter password for the password.
Note
: You can change the password, but not the login name, on the
System
screen.
7. You will then see the
Home
screen.
8
