ALL0274 User Guide
Modes
Your ALL0274 has 4 modes:
•
Config Mode
– used for configuration only.
•
AP (Access Point) Mode
.
•
AP/Router Mode
– both AP and Router.
•
Client Mode
- the ALL0274 is connected to your PC's Ethernet port, and converts that port
to a Wireless interface. You PC can then use the ALL0274 to join a Wireless network.
The mode is set ONLY by the mode selector switch on the side of the ALL0274. (You will
need to wait a few seconds after changing modes.)
It is important to understand these different modes, and the benefits and limitations of each.
Config Mode
Use this mode to any perform any required configuration. In Config mode, the following
settings are always used.
Password
The current password is used.
The Default password is blank.
If the password is set, you must use
admin
as the login name.
IP address
192.168.0.1
(Mask:
255.255.255.0
)
DHCP Server
Enabled (for both Ethernet & Wireless)
SSID
default
Wireless Security
Disabled
You can connect to the ALL0274 using either the Wireless interface or the wired Ethernet
connection. Using the Wired connection is recommended.
See the later section
Initial Configuration
for details.
4
