Allied 4001, Техническое руководство, Страница: 64 / 73

Inspect the internal operating parts
(striker and valve stem components)
for dirt or other contamination that
will hinder proper operation.
3. Flush contaminated parts with clean
hydraulic fluid. Use mineral spirits to
remove persistent contamination.
4. Use clean cloths to wipe away excess
cleaning fluids.
5. Repeat steps 2 through 4 until the
parts are ready for assembly. Proceed
to 11.9.
11.9 Body/Anvil and Tail Assembly
~
WARNING
The Body/Anvil and Striker are
heavy. Bodily injury could result
from improper handling of heavy
components.
1. Place the Body/Anvil (1) on the work
surface. Block so the open end is easily
accessible and the Body/Anvil will not
accidentally roll off the work surface.
Refer to Figure 11-24.
2. If the Striker (2) has been removed
from the Body/Anvil for cleaning:
a. Lightly coat the Striker with hydrau-
lic fluid before re-installing it into
Body/Anvil (1).
b. Refer to Figure 11-25, and slide the
Striker (2) into the Body/Anvil (1).
The back end of the Striker should be
about 6 in. to 8 in. past the threads of
the Body/Anvil.
3. Apply anti-seize thread lubricant spar-
ingly to the threads of the End Cap (9)
and the Body/Anvil (1) as shown in Fig-
ure 11-26.
4. With the exception of the End Cap (9)
and Whip Hose (14), lightly coat the
tail assembly components with hy-
draulic fluid.
5. Insert the Valve (6) into the Striker (2)
and thread the End Cap (9) into the
Body/Anvil (1). See Figure 11-27.
6. Hand tighten the End Cap (9) to the
Body/Anvil (1).
7. Place the Hole-Hog on a level surface.
Holding the Body/Anvil (1) with a strap
wrench, use wrench P/N 834017 to
tighten the End Cap (9), as shown in
Figure 11-28.
8. The End Cap should be tightened to a
torque of 550 ft.-lbs (745 nm). If a
torque wrench is not available, use the
following procedure. See Figure 11-29.
a. After tightening the End Cap hand
tight, put a scribe mark on the End
Cap next to the Body/Anvil.
b. Measure from the scribe line 1-inch
+1/8-inch and put another scribe
mark on the Body/Anvil.
c. Using P/N 834017 wrench, or equiva-
lent, tighten the end cap until the
mark on the end cap is in alignment
with the mark second on the body
within the tolerance indicated.
A
LLIED 4000C Series Hole-Hog
03/20/03 57