
1.
Place the Whip Hose components and
Q.D. fittings on the assembly bench.
These items are listed below and illus-
trated in Figure 11-12.
·
Whip Hose (13) - new 100R2 hose
only
·
Valve Nut (12) with Roll Pin (11)
·
Hose Socket (14) - quantity 2
·
Q.D. Plug (15)
·
Q.D. Gasket (16)
·
Q.D. Socket (17)
·
Supply Hose (optional)
11.6.1. Assemble Q.D. Socket Fittings
1.
Refer to Figure 11-13 and install a new
Gasket (16) in the Quick Disconnect
(Q.D.) Socket (17).
a. Hold the Gasket (16) with the
grooved face toward the Quick Dis-
connect (Q.D.) Socket (17).
b. Squeeze the sides of the gasket and
insert one end of the new Gasket into
the Socket.
c. Press the Gasket into its seat with
fingers or a blunt tool.
d. Check that the gasket seats securely
in the socket.
2.
With its
larger internal bore (hose
end) facing up, clamp the Hose Socket
(14) in a vise, as shown in Figure 11-14.
NOTE
The threads on the hose side of the
Hose Socket are left hand threads.
Turn the hose:
·
Clockwise to loosen.
·
Counterclockwise to tighten.
3.
Thread the Supply Hose end into the
Hose Socket, turning the hose coun-
terclockwise until it bottoms in the
Hose Socket.
4.
Back the Supply Hose out of the Hose
Socket ½ of a turn clockwise.
This allows linear expansion of the
hose when it is compressed by tighten-
A
LLIED
4000C Series Hole-Hog
51
A
B
Q.D. Socket
Hose Socket
Supply Hose
Q.D. Socket taper locks
Supply Hose in Hose Socket
Figure 11-15. Thread Tapered End of Q.D.
Socket into Hose Socket.
Содержание 4001
