Allied 4001, Техническое руководство, Страница: 39 / 73

(13) and tail assembly components to
the work area for reassembly.
2. Install all of the assemblies in the
Body/Anvil following the assembly pro-
cedures in this section, starting with
section 9.8.
9.4 Assemble End Cap Components
1. Lubricate the O.D. of the Shock Ab-
sorber (8) and the I.D. of End Cap (9).
Position the End Cap (9) in an arbor
press with the threaded end up as shown
in Figure 9-1-A.
2. Center the Shock Absorber (8) over the
threaded end of the End Cap (9) as
shown in Figure 9-1-A.
3. Center the press plunger or a pusher bar
over the Shock Absorber.
~
CAUTION
DO NOT press Shock Absorber past
the seat at the non-threaded end of
the End Cap.
4. Press the Shock Absorber into the End
Cap until it seats against the shoulder at
the non-threaded end of the cap as
shown in Figure 9-1-B.
5. Before installing the Valve Body Nut
(14), refer to Figure 9-2, and lubricate:
· the outer surface of the Valve Body
Nut (7).
· the I.D. of the Shock Absorber (8).
6. Center the Valve Body Nut (14) over the
bore of the shock absorber as shown in
Figure 9-2-A.
7. Center the press plunger or a pusher bar
over the Valve Body Nut (7).
8. Press the Valve Body Nut (7) into the
Shock Absorber (8) until the shoulder of
the Valve Body Nut seats against the
Shock Absorber, as shown in Figure
9-2-B.
9. Turn the End Cap (9) over in the arbor
press so the threaded end is down as
shown in Figure 9-3.
10.Look inside the non-threaded end of the
End Cap and lubricate that part of the
A
LLIED 4000C Series Hole-Hog
32
B A
End Cap
Shock
Absorber
Figure 9-1. End Cap and Shock Absorber in
Press
B A
End Cap
Shock
Absorber
Valve Body
Nut
Lubricate
Lubricate
Figure 9-2. Press the Valve Body Nut into the
Shock Absorber.