Allied 4001, Техническое руководство, Страница: 49 / 73

Tighten the Valve Nut until it just
reaches the end of upper threads on the
Valve Stem.
9.8 Assemble Body/Anvil, Striker and Tail
Assembly
NOTE
The Body/Anvil and Striker are not
customer serviceable. If these com-
ponents are worn or damaged, re-
place them with new components.
~
WARNING
The Body/Anvil and Striker are
heavy. Bodily injury could result
from improper handling of heavy
components.
1. Place the Body/Anvil (1) on the work
surface. Block so the open end is easily
accessible and the Body/Anvil will not
accidentally roll off the work surface.
Refer to Figure 9-22.
2. Coat the Striker (2) with hydraulic fluid
before installing it into Body/Anvil (1).
3. Refer to Figure 9-23 and slide the
Striker (2) into the Body/Anvil (1). The
back end of the Striker should be about
6 in. to 8 in. in (past the threads of the
Body/Anvil).
4. Apply anti-seize thread lubricant spar-
ingly to the threads of the End Cap (9)
and the Body/Anvil (1). See Figure 9-24.
5. With the exception of the End Cap (9)
and Whip Hose (13), coat the tail assem-
bly components with hydraulic fluid.
6. Insert the Valve (6) into the Striker (2)
and thread the End Cap (9) into the
Body/Anvil (1), as shown in Figure 9-25.
7.
Hand tighten the End Cap (9) to the
Body/Anvil (1).
8. Place the Hole-Hog on a level surface.
Holding the Body/Anvil (1) with a strap
wrench, use wrench P/N 834017 to
tighten the End Cap (9), as shown in Fig-
ure 9-26.
9. Tighten the End Cap to a torque of 550-
ft.-lbs (745nm). If a torque wrench is not
available, use the following procedure.
See Figure 9-27.
a. After tightening the End Cap hand
tight, put a scribe mark on the End
Cap next to the Body/Anvil.
b. Measure from the scribe line 1-inch
+1/8-inch and put another scribe
mark on the Body/Anvil.
c. Using P/N 834017 wrench, or equiva-
lent, tighten the end cap until the
mark on the end cap is in alignment
with the mark on the body within the
tolerance indicated.
A
LLIED 4000C Series Hole-Hog
42 03/20/03