Allied 4001, Техническое руководство, Страница: 30 / 73

sembly and Striker from the Body/Anvil
(paragraph 8.5), clean and inspect the in-
ternal components while they are still as-
sembled. After cleaning and inspection,
perform only the minimum disassembly re-
quired to replace worn or broken parts.
8.3 Whip Hose Replacement
• To Replace the Whip Hose (14) in the
field, refer to paragraph 11.1.
• To Replace the Whip Hose (14) as part of
shop disassembly, follow the procedures
in this section, starting with 8.6.1.
8.4 Replacing The Body/Anvil
When replacing the Body/Anvil (1) only, it
is not necessary to disassemble the Whip
Hose (13) and tail assembly components.
1. Remove Striker (2) and the assembled
Whip Hose (14) and tail assembly as
described in paragraph 8.5.
2. Until the new Body/Anvil is installed,
place the Striker (2), Whip Hose (13)
and tail assembly where they will not
be contaminated with dust and dirt.
Cover or wrap them in cloth or plastic
as required.
8.5 Removing Tail Assembly and Striker
1.
Place the Hole-Hog on a level surface.
Holding the Body/Anvil (1) with a strap
wrench, use wrench P/N 834017 to
loosen the End Cap (9). It may be nec-
essary to strike the wrench handle sev-
eral times with a hammer to loosen the
End Cap. Refer to Figure 8-2.
2.
R e m o v e t h e t a i l a s s e m b l y b y
unthreading the End Cap (9) and pull-
ing the Tail Assembly from the
Body/Anvil (1) as shown in Figure 8-3.
3. Place the Tail Assembly where it will
not be contaminated with dust and
dirt. Wrap in cloth or plastic if neces-
sary.
4. Remove the Striker (2) from the
Body/Anvil (1):
a. If it is unsafe or impractical to lift the
Body/Anvil and Striker, use a long
hook to pull the Striker out of the
Body/Anvil about six to eight inches
as shown in Figure 8-4. Otherwise,
perform step b.
23
A
LLIED 4000 Series Hole-Hog
Apply Wrench 834017
to End Cap.
Apply Strap or Chain
Wrench to Body/Anvil.
Figure 8-2. Loosening the End Cap.
Figure 8-3. Removing Tail Assembly.
Figure 8-4. Access the Striker with a Hook.