Allied 4001, Техническое руководство, Страница: 36 / 73

8.6.4 Disassemble End Cap Components
~
CAUTION
Removal destroys Shock Absorber.
DO NOT remove Shock Absorber
(8) and Valve Body Nut (7) from
End Cap (9) unless replacement is
necessary.
1. Use a sharp knife or hack saw to cut
through the Valve Seal (10). Using a
large screw driver or needlenose
plyers, pry the Valve Seal from the End
Cap. Discard the Seal. See Figure 8-20.
2. With threaded end down, place the
End Cap in the arbor press as shown in
Figure 8-21.
·
Support the edges of the End Cap (9)
with standard blocking.
· Provide additional space below the
blocking to permit Valve Body Nut
(7) travel during pressing.
3. If the plunger of the arbor press does
not fit inside the End Cap, use a
standard push bar of the required
diameter, as shown in Figure 8-21.
4. Press the Valve Body Nut (7) from the
Shock Absorber (8) as shown in Figure
8-22-A.
5. Once started from the Shock Absorber,
the Valve Body Nut (7) can be pulled
free by hand. Refer to Figure 8-22-B.
A
LLIED 4000C Series Hole-Hog
29
End Cap
Shock Absorber
Valve Body
Nut
Standard Pusher Bar
Blocking to Support
End Cap
Figure 8-21. End Cap in Arbor Press.
B A
End Cap
Shock
Absorber
Valve Body
Nut
Blocking to Support
End Cap
Figure 8-22. Remove Valve Body Nut from the
End Cap.
Figure 8-20. Removing the Valve Seal from the
End Cap.