Allied 4001, Техническое руководство, Страница: 43 / 73

7. Start the tapered end of the Q.D. Socket
(17) into the Hose Socket. See Figure
9-10-A.
8. Apply a 2-inch open-end wrench across
the flats of the Q.D. Socket (17), and
thread it into the Hose Socket (14). See
Figure 9-10-B.
The taper of the Q.D. Socket moves into
the Hose Socket and inside the
Supply
Hose. As the larger end of the taper ex-
pands the Supply Hose and presses it
against the Hose Socket, the Supply Hose
is locked in place between the Q.D. Socket
and the Hose Socket.
9. Tighten the Q.D. Socket just enough to
secure the two sockets together and se-
cure the supply hose in the Hose Socket.
Overtightening can damage the hose
and it may pull apart under tension.
9.6.2. Assemble Q.D. Plug to Whip Hose
~
WARNING
Always use Allied’s Whip Hose
Assembly (see parts list in Section
13.0) or equivalent: 100R2 hose.
Failure to use 100R2 hose could re-
sult in injury to personnel.
1. With its larger internal bore (hose end)
facing up, clamp the Hose Socket (15) in
a vise, as shown in Figure 9-11.
NOTE
The threads on the hose side of the
Hose Socket are left hand threads.
Turn the hose:
· Clockwise to loosen.
·
Counterclockwise to tighten.
2. Thread one of the Whip Hose (13) ends
into the Hose Socket, turning the hose
counterclockwise until it bottoms in the
Hose Socket.
3. Back the Whip Hose out of the Hose
Socket ½ of a turn clockwise.
This allows linear expansion of the hose
when it is compressed by tightening the
Q.D. Plug (15).
4. Remove the assembled Hose Socket and
Whip Hose from the vise.
5. Apply a 2-inch open-end wrench across
the flats of the Hose Socket (14) to hold
the assembled hose and socket in place.
A
LLIED 4000C Series Hole-Hog
36
A
B
Q.D. Socket Hose Socket Supply Hose
Q.D. Socket taper locks
Supply Hose in Hose Socket
Figure 9-10. Thread Tapered End of Q.D.
Socket into Hose Socket.
Hose Socket
Whip Hose
Hose Socket has
left-hand threads.
Thread Whip Hose
counterclockwise
into the Hose Socket
Figure 9-11. Hose Socket and Hose in Vise.