Allied 4001, Техническое руководство, Страница: 31 / 73

24
b. Tip the Body/Anvil (1) so the end of
the Striker (2) slides out of the
Body/Anvil about six to eight inches.
(Figure 8-5).
5. Once the Striker (2) is accessible, lower
the Body/Anvil (1) to the level surface
and block it to prevent rolling. Pull the
Striker from the Body/Anvil by hand as
shown in Figure 8-6.
6. Place the Striker where it will not be
contaminated with dust and dirt. Wrap
in cloth or plastic if necessary.
7. Cover the open end of the Body/Anvil to
prevent contamination of the interior
and threads. Coat threads with grease if
long-term storage is anticipated.
8.6 Disassembling the Tail
Assembly
NOTE
DO NOT disassemble components
of the tail assembly unless replace-
ment is necessary.
8.6.1 Remove Whip Hose and End Cap
1. Position the Tail Assembly in a vise so
the End Cap (9) and Whip Hose (13) are
above the vise jaws. The Valve (6)
should be below the jaws, as shown in
Figure 8-7.
2. Be sure the valve does not get caught in
or interfere with vise components be-
low the jaws.
3. Secure the Tail Assembly in the vise by
clamping the jaws firmly across the flats
of the Valve Stem (4) as shown in Figure
8-7.
4. Fit a 2-3/8-inch open-end wrench across
the Valve Nut flats. Loosen the Valve
Nut.
A
LLIED 4000 Series Hole-Hog
Valve Nut Flats
Valve Stem Flats
in Vise Jaws
Figure 8-7. Place End Cap in Vise.
Secure Hole-Hog to
Lifting Device with
Lifting Strap or Chain
Block Hole-Hog
Side to Side to
Prevent Rolling
While Lifting
Block End of Hole-Hog
Above Work Surface to
Allow Striker to Slide Free
Figure 8-5. Tilting the body/anvil to Access the
Striker.
Figure 8-6. Striker Removed from Body/Anvil.