AT-IE510 Series Installation Guide
93
Activating the VCStack Feature
When a switch displays the number “0” in its ID LED you must activate the
VCStack feature to install a VCstack. The following procedures assume
you have confirmed that the VCStack feature is disabled and that the
switch is powered on.
To activate the VCStack feature, perform the following procedure:
1. Start a local management session. Refer to “Starting a Local
Management Session” on page 91 for instructions.
2. Enter the ENABLE command to move from the User Exec mode to the
Privileged Exec mode, as shown in Figure 50.
Figure 50. Moving to the Privileged Exec Mode with the ENABLE
Command
3. Enter the CONFIGURE TERMINAL command to move to the Global
Configuration mode, as shown in Figure 51.
Figure 51. Moving to the Global Configuration Mode with the CONFIGURE
TERMINAL Command
4. Enter the STACK ENABLE command to activate VCStack on the
switch, as shown in Figure 52:
Figure 52. Activating VCStack with the STACK ENABLE Command
5. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 53.
awplus> enable
awplus#
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
awplus(config)# stack enable
% The device needs to be restarted for this change to take effect.
awplus(config)#
Содержание AT-IE510-28GSX-80
