Allied Telesis AT-IE510-28GSX-80, Руководство по установке

Страница: 84 / 126

Chapter 7: Configuring the Switch for Stand-alone Operations
84
Figure 42. Moving to the Global Configuration Mode
5. To. disable the VCStack feature on the switch, enter the NO STACK
ENABLE command, which has this format:
no stack
id
enable
The ID parameter is the ID number of the switch, displayed on the ID
LED. Replace the parameter with whatever number is on the ID LED.
For example, if the ID number of the switch is 1, the default value,
enter the command as follows:
awplus(config)# no stack 1 enable
This confirmation prompt in Figure 43 is displayed.
Figure 43. Confirmation Prompt for the NO STACK ENABLE Command
6. Type Y to disable VCStack on the switch or N to cancel the procedure.
7. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 44.
Figure 44. Returning to the Privileged Exec Mode
8. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 45.
Figure 45. Saving the Changes with the WRITE Command
9. Enter the REBOOT command to reboot the switch.
10. At the confirmation prompt, type “Y” for yes.
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z
awplus(config)#
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#