Allied Telesis AT-GS950/48, Руководство пользователя

Страница: 222 / 410

Chapter 16: SNMPv1 and v2c
222
5. Enter the Host IP Address for the management device that is to
receive the SNMP traps in one of the Host IP Address fields:
For an IPv4 address, click IPv4 , then enter the address using
xxx.xxx.xxx.xxx format.
For an IPv6 address, click IPv6 , then enter the address using
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format.
6. Enter the SNMP Version , either v1 or v2c , that is configured for the
host management device.
7. Enter a Community Name that you have defined previously in the
SNMP Community table.
Note
The Community Name must correlate with one of the communities
displayed on the SNMP Community Table page. See “SNMP
Community Strings” on page 218. If you enter a
Community Name
that has not been pre-defined, the Trap Host entry is displayed, but
agent/manager communication fails.
8. Click Add .
The new host is added to the table. An example of a host is shown in
the table at the bottom of Figure 82.
Figure 82. Trap Management Page Example
9. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
Modify a Trap
Host Table Entry
If you need to modify an SNMP Trap entry, you must first delete the entry
by using the procedure below and then re-enter it with the modification by
creating a new SNMP trap- see “SNMP Traps” on page 221.