Allied Telesis AT-GS950/48, Руководство пользователя, Страница: 168 / 410

Chapter 13: Virtual LANs
168
Enabled - This parameter enables management access on this
VLAN.
Note
- If you enable management on a VLAN other than 1, you can
access management only through a tagged port of that VLAN.
- You can access management through the tagged port of all VLANs
on which you have enabled management.
- You can still access management through a port that is only an
untagged member of VLAN 1 and not a tagged member of another
VLAN.
Disabled - This parameter disables Management VLAN on this
VLAN. If you change this parameter from Enable to Disable , the
Management VLAN is still enabled on the DefaultVLAN .
Note
The Management VLAN is always Enabled on the untagged ports of
the DefaultVLAN. It cannot be disabled on the DefaultVLAN.
7. To assign ports to the VLAN, click on the port numbers labeled either
Static Tagged or Static Untagged .
To assign all ports to the VLAN as Static Tagged , click All under
Static Tagged .
To assign all ports to the VLAN as Static Untagged , click All under
Static Untagged .
By default, all the ports are assigned to the Not Member category
when a specific VLAN is created. The Not Member ports are either
part of the DefaultVLAN (VLAN ID=1) or another VLAN.
8. Click Apply .
9. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.
Modify a Tagged
VLAN
To modify the name or port assignments of a tagged VLAN, perform the
following procedure:
1. From the main menu on the left side of the page, select Bridge .
The Bridge folder expands.
2. From the Bridge folder, select VLAN .
The VLAN folder expands.
3. From the VLAN folder, select Tagged VLAN .
An example of a tagged VLAN is shown in the table at the bottom of
Figure 58.