Allied Telesis AT-GS950/48, Руководство пользователя, Страница: 156 / 410

Chapter 12: Storm Control
156
Egress Rate Limiting
This procedure explains how to set Bandwidth levels and Status for
Egress Rate Limiting on each port of the AT-GS950/48 switch.
To change the settings of the egress rate limiting feature, perform the
following procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
2. From the Bridge folder, select Bandwidth Control .
The Bandwidth Control folder expands.
3. From the Bandwidth Control folder, select Egress Rate Limiting .
The AT-GS950/48 Egress Rate Limiting page is displayed. See Figure
55 for a partial view of this page.
Figure 55. AT-GS950/48 Egress Rate Limiting Page
To set the Bandwidth field, enter a number in the range of 1 to 15625.
You can select the All row to set all of the ports to the same setting.
Note
See “Egress Rate Limiting” on page 151 for calculating the
bandwidth limit set by the
Bandwidth field.
4. To enable or disable the egress rate filter, select Enable or Disable
from the Status pull-down menu next to the port that you want to
change. You can select the All row to set all of the ports to the same
setting.
The
Ignore parameter indicates that the setting in the All row does not
apply to the Status menu for individual ports.
5. Click Apply .
6. From the main menu on the left side of the page, select Save Settings
to Flash to permanently save your changes.