Alfa Romeo Tonale, Руководство пользователя

Страница: 216 / 296

IN CASE OF EMERGENCY
214
JUMP STARTING
If the conventional battery is flat, jump
starting can be performed using cables
and the battery of another car, or using
a booster battery with equal or slightly
higher capacity than the discharged one.
78)
WARNINGS
When a booster battery is used, comply
with the use and precaution instructions
specified by the producer.
Do not use the booster battery or any
other source of external supply with a
voltage above 12 V: the conventional
battery, the starter (where provided),
the alternator (where provided) and the
electrical system of the vehicle could be
damaged.
Do not attempt jump starting if the
conventional battery is frozen. The
battery could break and explode!
JUMP STARTING
185) 186) 187) 79)
When jump starting, never connect the
negative cable (-) of the auxiliary battery
to the negative pole (1) fig. 225 of the
conventional car battery. The following
spark could lead to battery explosion and
cause serious harm. Only use the specific
earth point; do not use any other exposed
metallic part.
WARNING Avoid contact between the
two vehicles since this could cause a
connection to earth and may result in
serious injury to any people nearby.
WARNING After setting the ignition
device to STOP and closing the driver's
door, wait at least two minutes before
disconnecting the electrical supply
from the traditional battery. When
reconnecting the electrical supply to the
conventional battery, make sure that the
ignition device is in the STOP position
and the driver's door is closed.
225
9650241
226
9650277
PROCEDURE FOR JUMP STARTING
WARNING If the procedure below is
carried out incorrectly, it can cause
severe injury to people or damage the
recharging system of one or both cars.
Carefully follow the instructions given
below.
Cable connection
Proceed as follows to carry out a jump
starting:
engage the parking brake
move the transmission lever to
position N and the ignition device to
STOP
WARNING With a fully discharged
conventional battery, if the gear lever
is in P (Park), it cannot be disengaged,
nor can the electric parking brake (EPB).
Therefore, to move the car, it must
be towed with all four wheels off the
ground.
switch off the additional heater (for
versions/markets, where provided), the
Alfa Connect system and all unnecessary
electrical accessories
remove the protective cover over the
battery's positive (+) pole
connect one end of the cable used for
positive (+) to the positive terminal (+) of
the car with flat conventional battery
connect the other end of the cable
used for positive (+) to the positive