UXSM Harness Installation
4200-088
10-3
Revision 1.03
Figure 25 - Recessed Post UXBM and UXSM Power Lead Assembly of Connections
The following illustration only gives one possible scenario of how the actual power supply leads are
connected to the battery. Make sure the UXBM and UXSM power leads are installed first, they should be
closest to the recessed battery post. Then the brass 2-tabbed washers, flat washer and lock washer with
bolt are installed and should be located on top of the power leads.
Torque all bolts/nuts to the manufactures specification when assembling the connections.
After connection has been made to the battery, connect the four pin connector into the POWER IN
connector on the rear of the UXCM. Then install each fuse within the fuse holders.
