Safety Information
4200-088
1-2
Revision 1.03
1.3.
Safety Symbols
The following symbols may appear on the system or individual equipment.
CAUTION. Risk of danger.
Equipment protected throughout by double insulation or reinforced insulation.
1.4.
Product Safety Practices
The following describe safety practices particular to the installation or operation of the product.
Equipment Service
Proper installation and testing are essential to the correct functioning of the system. If you have
questions, contact Albér and request monitor assistance. Except as explained in this manual, do not
attempt to service Albér equipment.
Any adjustment, maintenance or repair of this product must be performed by qualified personnel.
Contact an Albér customer service engineer and request assistance. Only qualified and trained
personnel may perform the operations described in this manual. All safety information must be read,
understood, and strictly adhered to before installing, powering up or using the equipment or software
(the "system".)
Equipment Grounding
To minimize shock hazard, the system chassis must be connected to an electrical protective earth
ground if/when required. When AC mains are used for the power source, the system must be connected
to the AC power mains through a grounded power cable, with the ground wire firmly connected to an
electrical safety ground at the power outlet.
Fuses
For continued protection, only the fuses with the required rated current, voltage, and specified type, i.e.
normal slo–blo, fast blow, time delay, etc. must be used.
Equipment Access
Operating personnel must not remove equipment covers, shields, and or panels. Component repair
and/or replacement and internal adjustments must be made only by qualified service personnel.
Operating Damaged Equipment
Do not operate damaged equipment. Equipment that appears damaged or defective must be made
inoperative and secured against unintended operation until repaired by qualified service personnel.
Whenever it is possible that the safety protection features built into this product have been impaired,
either through physical damage, excessive moisture or any other reason, remove power and do not use
the product until safe operation can be verified by qualified service personnel. If necessary, contact
Albér to ensure the safety features are maintained.
