UXSM Harness Installation
4200-088
10-2
Revision 1.03
Figure 23 - UXSM Power Connector
At the opposite end of the wires, connect the fuse assemblies by properly crimping them directly into
the fuse holder. Shrink tubing has been provided to allow covering of this crimp so be sure to place the
shrink tubing over the wire before attaching the fuse holder.
The following illustration only gives one possible scenario of how the actual power supply leads are
connected to the battery. Make sure the UXCM and UXSM power leads are installed first, they should be
closest to the battery post. Then the brass 2-tabbed washers, flat washer and lock washer with nut are
installed and should be located on top of the power leads.
Torque all bolts/nuts to the manufactures specification when assembling the connections.
Figure 24 - Exposed Post UXBM and UXSM Power Lead Assembly of Connections
