AIRTRONICS SD-6G, Руководство по эксплуатации

Страница: 42 / 92

Page 42
aERO MODEL TyPE
Choosing the Flight Mode - Common or Separate
1) From the Display screen, press the ENTER key to display the Programming
Menus.
2) Press the Navigation Pad
56
to highlight FL
4
EL, then press the
ENTER key to display the FL
4
EL menu. The cursor will default to
FL
4
EL>0%.
The channel options displayed will differ based on the Model Type selection options you chose previously. For example, if
you chose TAIL>2xEL in the TYPE menu, FL
4
LE (Left Elevator) and FL
4
RE (Right Elevator) percentage values can be
changed separately.
3) Press the Navigation Pad
5
to move the cursor to F-MODE>COMMON.
4) Press the INC+/M1 or DEC-/M2 keys to choose either SEPARATE or
COMMON.
17.FL
4
EL (FLaP TO ELEvaTOR MiXing), cOnTinUED....
Changing Flap to Elevator Mixing Percentage Values
FL
4
EL setting range is -100% to 100%. The default setting is 0% (OFF). When the percentage value is increased from 0% to
100%, elevator travel will increase in one direction in relation to flap travel. When the percentage value is decreased
from 0% to -100%, elevator travel will increase in the opposite direction in relation to flap travel.
The Flap
4
Elevator Mixing percentage value is a ratio of elevator
travel to flap travel. For example, when the Flap
4
Elevator Mixing
percentage value is set to 10%, the elevator will travel 1/10th the amount
that the flaps travel. This mix is Linear.
1) Press the Navigation Pad
6
to highlight FL
4
EL>0%, then press the
INC+/M1 or DEC-/M2 keys to change the Flap
4
Elevator Mixing
percentage value.
18.DUaL EL (DUaL ELEvaTOR MiXing EnD POinT aDjUSTMEnT)
The Dual Elevator Mixing End Point Adjustment function allows you to adjust the servo travel of each elevator servo independently
while the Dual Elevator Mixing option is Active. In some cases, when you use two separate elevator servos, minor differences in
control linkage geometry can result in one elevator half deflecting more in one or both directions than the other elevator half. The
Dual Elevator Mixing End Point Adjustment function allows you to reduce the control deflection of one or both elevator halves in
either direction to ensure that both elevator halves deflect exactly the same amount.
For greater flexibility, the Dual Elevator Mixing End Point Adjustment function can be programmed either the same for all Flight
Modes or separately for each of the three Flight Modes.
5) If you choose SEPARATE, press the F-MODE key to choose the F-MODE number you would like to program the Flap to Elevator
Mixing function for. Choose from FN, F1 or F2.
IMPORTANT
Depending on the specific orientation of your elevator control linkages, in order for the Dual Elevator Mixing
function to work as intended, one of the elevator servos may need to be reversed (using the NOR/REV setting in the
REVERSE menu), so that both control surfaces move Up and Down together using the elevator control stick.