Airo A16 J Series, Руководство пользователя

Страница: 83 / 128

User’s Manual – A16 J A18 J Series Page 83
7.4.3. TRAVEL battery recharge.
ATTENTION!
EXPLOSIVE gas is originated during battery charging process. Therefore, charging must take
place in airy rooms where no risks of fire and explosion exist and in the presence of fire
extinguishers.
Connect the battery charger to a power supply having all protections according to the current standards and with the
following features:

Supply voltage 230V ± 10%

Frequency 50÷60 Hz

Activated grounding line

Magneto-thermal protection switch and residual current device (“circuit breaker”)
Moreover:

Do not use extension leads exceeding 5 metres to connect the battery charger to the power supply.

Use a cable of a suitable section (min 3x2.5 mm2).
 Do not use rolled-up cables.
DO NOT
connect the machine to power networks that do not comply with the above-mentioned features.
Failure to observe the above-mentioned instructions may result in malfunctioning of the battery
charger with consequent damage not covered by the guarantee.
ATTENTION!
After charging and with the battery charger is still connected to power supply, the electrolyte
density values should range from 1.260 g/l to 1.270 g/l (at 25°C).
To use the battery charger, follow this procedure:
 connect the battery charger by means of plug A to a current socket with the a.m. features.
 check the connection state of the battery charger through led B . If it is on, connection has taken place and charging
has started. The colour and enable mode of the led indicate the charging phase (refer to table below).
Fig.32