Airo A16 J Series, Руководство пользователя

Страница: 69 / 128

User’s Manual – A16 J A18 J Series Page 69
7.2.5. Check the oil level in the main reduction gear (for travel) and change it, if needed.
The oil level should be checked at least once a year.
Place the machine to have the two plugs (
A and B ) in the
position shown in the picture aside (in some cases you
must remove the driving wheels to reach out for these
plugs). Check the level by means of plug ( A ). Always
check the oil level when the oil is hot. The level is correct
when the reduction gear is full of oil up to the A -plug rim.
Should more than 10% oil be missing, before topping-up
check for a possible oil leakage in the system. Do not mix
different types of oil, of the same or of different brands. Do
not mix mineral oils and synthetic oils.
Fig.23
The oil must be changed the first time after 50-100 working hours, and afterwards after every two years. Depending on
the actual operating conditions, these intervals may be varied for each single case. While changing the oil, wash the
internal parts of the casing with the fluid recommended by the lubricant producer. To avoid sludge deposits, the oil must
be changed when the reduction gear is hot. To change the oil, undo the plug B , and place a container of a 2 l. capacity
beneath it. Drain the reduction gear completely, clean it as described above and then fill it up to the limit level of plug A
through the same hole (for max. capacity see following table).
SYNTHETIC OILS
0.5 l per motor
ESSO Compressor Oil LG 150
AGIP Blasia S 220
4° Year Alpha SN 6
IP Telesia Oil 150
BIO OILS - OPTIONAL
PANOLIN PANOLIN
7.2.5.1 Periodical check-ups of synthetic biooil in the main (travel) reduction gears
Quarterly or every 500 hours check the oil level. If needed, top it up. If you see more than 10% of oil lacks from the gear,
check for leaks.
Change the oil in the slewing reduction gear after the first 100 hours of operation and then every 6000 hours or every 3
years.
Depending on the actual operating conditions, these intervals may change.
When changing the oil, run a wash cycle inside the casing.
Change the oil when the reduction gear is hot.
Mixtures of different oils (either biodegradable or mineral) even of the same brand are not allowed.
During oil change or topping up, do not discard the hydraulic oil in the environment.