User’s Manual – A16 J A18 J Series
Page 32
3.3.
General
3.3.1.
Use and Operating instructions.
The electric and hydraulic systems are provided with safety devices, calibrated and sealed by the manufacturer:
DO NOT TAMPER WITH AND MODIFY THE CALIBRATION OF ANY COMPONENT OF THE ELECTRIC
AND HYDRAULIC SYSTEMS.
The machine must be used only in areas well lit up, checking that the ground is flat and firm. The machine may
not be used if the lighting conditions are not enough. REMEMBER: the machine has no built-in lightening
system.
Before using the machine check its integrity and good, functional preservation state.
During maintenance operations do not dispose of any waste materials in the environment but comply with
current regulations.
Do not carry out any service or maintenance operations while the machine is connected to the mains supply.
Follow the instructions given in the following paragraphs.
Do not near any part of the electric and hydraulic systems to heat or flame sources.
Do not try to reach higher than the max. admissible height, especially using scaffolding, ladders, or other tools.
With the machine lifted, do not fasten the platform to any structure (beams, pillars or wall).
Do not use the machine as a crane, hoist or lift.
Protect the machine and the control panel on the basket by means of the special (optional) cover. Make sure
the operator is safe when working in adverse conditions (painting, de-painting, sand-blasting, washing, etc.).
Using the machine in bad weather conditions is forbidden; Wind speeds must not exceed the limits indicated
under “Technical Features” (to measure speeds, see following chapters).
Machines with a wind speed limit of 0 m/s are to be used indoors only.
In the event of rain or when the machine is parked, always cover the control panel on the basket by means of
the special hood or guard (optional).
Do not use the machine in any room or place at deflagration or fire risk.
Do not use pressurized water jets (high-pressure cleaners) to wash the machine.
Overloading the work platform is forbidden.
Avoid knocks and/or contacts with other vehicles and fixed structures.
Leaving or accessing the basket is forbidden unless this is in the position required for access or leaving (see
the chapter “Accessing the Basket”).
3.3.2.
Handling
Before moving the machine make sure that it has been disconnected from the power supply source. Always
check the position of the cable during handling, if the machine is powered with a 230V electric pump.
To avoid any instability, strictly use the machine on regular and firm grounds. To prevent the machine from
overturning, comply with the max. gradeability values indicated in the section “Technical Features” under
paragraph "Stability limits". However, movements on inclined grounds are to be carried out with the utmost
caution.
As soon as the basket is up high, (the tolerance varies from model to model) the safety drive speed is
automatically activated (all models of this handbook have passed the stability tests in compliance with
standard EN280:2001 ).
Drive the machine with a lifted basket only on flat grounds, verifying the absence of holes or steps on the floor
and bearing in mind the overall dimensions of the machine.
No horizontal loads should be in the basket, while the machine travels with a lifted basket (operators on board
are not allowed to pull wires or ropes, etc.).
Do not use the machine for road transportation. Do not use the machine for transporting any materials (see
chapter “Application Field”).
Make sure that there are no obstacles or impairment to travelling and operating within the site area.
Pay attention to the area above the machine during lifting to avoid any crushing and collisions.
While handling or operating, make sure your hands never infringe a dangerous area. Drivers should keep their
hands as shown in picture A or B, whilst passengers should hold their hands as in C.
Содержание A16 J Series
