Airo A16 J Series, Руководство пользователя

Страница: 52 / 128

User’s Manual – A16 J A18 J Series Page 52
5.4.3. Starting the 3-phase electric pump (OPTIONAL).
Diesel powered models can be equipped, on request,
with a 380V three-phase electrical pump.
To start the three-phase electrical pump:
 Insert the 380 V plug of the power cable into
socket (A) on the chassis.

Set the switches (C) pictured here to ON.
 Set the red switch (F) to ON turning it
downwards or upwards. If the connection has
been successfully carried out it is possible to
start the electrical pump as indicated in next
paragraphs. On the contrary, in the event of a
phase fault in the electric power the alarm is
automatically enabled, and the electrical pump
cannot be started. In this case, it is possible to
optimise the power phases by turning the
angular red switch (F) on the electric case by
90°.
 To start the electrical pump from the control
panel on the platform, you must:
o
Select the control panel on the basket
by means of the key-switch located on
the electric control unit on ground;
o
Unlock the push-button turning by a ¼
of turn clockwise.
o
Set the power selector to "Electric".
o
Select 380V.
o
Press the push-button (O). When ON,
the green pilot indicates that the three-
phase electrical pump is turned on.
o
Wait 5 seconds before moving the
machine.
 To stop the electric pump press button (O)
again.
Fig. 11
Please note:m powered by 380V electric power can be operated only from the platform.
The manoeuvres powered by a 380V pump are considerably slower than those powered by the diesel engine.
PLEASE NOTE: The Diesel engine can be started only if the dead-man pedal is neither pressed nor
enabled. This means that the electrical pump can be started only if the platform green warning light
ON is flashing.
CAUTION! Always check the position of the power cable during transfers and operating motions.
Disconnect all power ports before you open any box.