Aichi SR12CSM, Руководство по эксплуатации с информацией по обслуживанию

Страница: 51 / 78

43
3‒2 Traveling
DANGER
• Before traveling, make sure that no person
or obstacle is in the traveling direction.
• When traveling, make sure to retract the
boom fully.
• When traveling, raise the boom so it is
almost horizontal, make sure you can see to
the front, and make sure you travel safely.
• All persons in the platform must comply
with employer, work area, and local and
national safety regulations regarding the
use of personal protective equipment.
Always use a safety harness in the platform.
Attach the lanyard to the authorized lanyard
anchorage point provided in the platform.
WARNING
• If traveling on a slope more than
maximum allowable tilt angle is
unavoidable, make sure to fully retract
the boom and lower the boom under the
horizontal.
- Maximum allowable tilt angle: 5°(8.7%)
• Before traveling onto a slope, approach
straight to the inclination direction. If
traveling obliquely, any track could leave
from the ground, resulting in tipping over.
• When you start traveling, make sure to
operate the controls gradually, and to start
slowly. It is dangerous to start abruptly.
Adjust the traveling speed by turning the
travel joystick controllers.
• Do not change course abruptly. The
platform will swing widely, and there is
a possibility the operator will be thrown
from the platform or the machine will tip
over.
• When traveling, make sure there is
enough distance between the traveling
surface and bottom of the platform, or
the tip of the boom. If there is not enough
distance, depending on the unevenness
of the traveling surface, the bottom of the
platform or the tip of the boom may come
in contact with the traveling surface, and
may be damaged.
• If the turntable has been rotated 180°,
the traveling direction will be opposite to
the joystick controller movements, so be
careful.
Make sure to check the direction of the
arrow on the decal and on the chassis
when traveling.
NOTICE
• If the machine tilts more than 5 degrees
while the boom is retracted fully and
raised to at least 45 degrees, the travel
function is stopped. (Refer to Section 3
“Travel Function Limit System” of Chapter
3.)
• The travel alarm buzzer sounds when the
machine is traveling to warn the people
nearby.
Use the travel control levers and the travel speed
select switch to travel the machine.
Travel Speed Select Switch
Travel control levers
M179D32-1
Fig. 8‒18
3‒2‒1 Travel Speed Select
WARNING
Engine rotations become high
automatically when high-speed traveling.
Do not operate the travel speed select
switch while traveling to avoid shocks
that are caused by sudden change of the
traveling speed.
1. Select “ ” (HIGH SPEED) for a high speed
traveling.
2. Select “ ” (LOW SPEED) for a low speed
traveling.