Aichi SR12CSM, Руководство по эксплуатации с информацией по обслуживанию

Страница: 33 / 78

25
12. Fuel Level Light
This light goes on when the fuel
level is low.
(On a level surface, the fuel level
light goes on at about 20 liters.)
NOTICE
• When the fuel level light goes on, refill the
diesel fuel.
• The capacity of the fuel tank is 95 liters.
13. Overload Warning Light
When the platform is
overloaded, this light will flash,
the alarm buzzer will sound
and all of the functions will be
disabled.
14. Not used
15. Tilt Light
This light will go on when the
machine tilts more than max
allowable tilt angle.
16. System Failure Light
This light will go on or flash in
the event of a computer control
system failure.
WARNING
Stop using the machine and contact AICHI
or an AICHI dealer for inspections, if this
light goes on or flashes.
17. Air Filter Clog Light
This light will go on when the air
filter is clogged.
If this light goes on while the
engine is in motion, clean or
replace the air filter element.
18. Charge Light
After starting the engine, this
light will go off.
If this light goes on while the
engine is in motion, check the
charging system, e.g. alternator
and fan belt.
19. Water Temperature Light
When the engine cooling
water temperature goes up
abnormally, the engine will
stop and this light will go on
to protect the engine from
overheat.
WARNING
When the engine is overheated, do not
remove the radiator cap, as the heated
water will splash out, resulting in scald.
CAUTION
If this light goes on during operations,
stop using the machine and check the
engine cooling system, e.g., shortage of
cooling water and broken fan belt.
20. Oil Pressure Light
After starting the engine, this
light will go off. Check the
engine lubrication system, e.g.,
shortage of engine oil, if this
light goes on while the engine is
in motion.
21. Preheat Light
This light will go on when
the key switch is turned to
“
” (LOWER CONTROLS) or “ ”
(UPPER CONTROLS) and then will
go off when the preheating is
completed.
NOTICE
If this light is flashing, operations of the
machine are disabled. In that case, release
hands from all controls and then operate
controls. (See “11. Enable Switch.”)