Aichi SR12CSM, Руководство по эксплуатации с информацией по обслуживанию

Страница: 64 / 78

56
Set the travel speed select switch to
“ ”
(LOW
SPEED).
Drive the machine straight forward or
backward at low speed onto the ramps.
After unloading the machine, turn the key
switch to “ ” (OFF) to shut down the engine,
remove the key to prevent using the machine
without permission, and store it suitably.
Unlock the turntable lock pin.
5. Hoisting the Machine
DANGER
• Make sure the transport vehicle capacity,
crane capacity, loading surfaces, sling
chains and wire ropes are strong enough
to withstand the machine weight. See
the serial number plate for the machine
weight.
• Do not allow any person to get under the
machine while hoisting.
• Do not pass the sling chains or wire ropes
except designated hoisting eyes.
• If there is damage, such as cracks, on the
hoisting eyes, immediately contact AICHI
or an AICHI dealer for repairs.
• Failure to heed warnings could result in
breaking, falling, or other hazards leading
to death or serious injury.
CAUTION
When the machine is excessively tilted,
battery fluid may leak out.
Retract and lower the boom fully.
Prepare sling chains or wire ropes according to
the Table 10‒1.
Pass the sling chains or wire ropes
through the hoisting eyes located
on the turntable as shown in the
figure below.
A
M179A42-1
Fig. 10‒6
Adjust the rigging to prevent damage to the
machine and to keep the machine level.
If necessary, use spreaders of sufficient
length to keep the slings from contacting the
turntable or booms.
When hoisting, the machine should be in the
posture of figure below.
Just before leaving off the ground, check the
balance, and operate the boom to adjust the
machine level as needed.
Table 10‒1 Hoisting Specifications
Model SR12CSM
Machine weight * 7 550 kg
Type of hitch 4‒leg bridle
Min. breaking load
196 kN
(20 000 kgf)
Min. leg length (same
length for all)
5 m
Center of gravity to travel
motor (Fig. 10‒6, A)
1.3 m
* The machine weight may vary with the option
configuration. See the serial number plate.