Aichi SR12CSM, Руководство по эксплуатации с информацией по обслуживанию

Страница: 17 / 78

9
• When the machine must travel to a
particular location and there is no other
option but to travel on uneven surfaces, up
and down steps, or on slopes exceeding
the maximum allowable tilt angle, obey
and observe as follows:
(1) Do not travel the machine on a slope
exceeding the machine gradeability. Failure
to follow instruction could tip over the
machine. The machine gradeability: refer to
Chapter 12.
(2) Traveling on slopes
(a) Climb perpendicular to the slope face
with the counterweight facing uphill.
(b) Do not change direction or turn to the
side while climbing a slope face. Change
direction after reaching level surface.
RIGHT
M085K603
Fig. 1‒25
(c) Descend perpendicular to the slope face
with the counterweight facing uphill.
(d) Do not park on the slope. If the machine
must park or stop on a slope, chock to
keep the machine from moving.
(e) Retract the boom fully and raise the
boom to the horizontal.
Rotate the boom to rear or front center
of the machine.
Adjust the boom rotation to become
parallel to the traveling direction.
(f) Do not rotate the boom while traveling
on a slope.
(g) Set the travel speed select switch to
“LOW” and travel at low speed.
(h) Slopes that are wet, slopes with sand
or gravel, and slopes with grass or
fallen leaves may cause the machine to
slip even on a slight gradient. On such
slopes, exercise extra caution so that the
machine does not turn on its side.
(3) Climbing up and down steps, traveling
on uneven surfaces, reaching the peak of
slopes, and at the start of climbs.
- Irrespective of how much the boom is
extended, never raise the boom angle to
a position greater than horizontal while
traveling as the machine will incline on
even minor bumps, steps, and slopes. The
machine will become unstable and the
machine may tip over. This may result in
serious accidents in which the worker on
the platform may become sandwiched
between a building or structures.
- Pay adequate attention when you have
no other option but to drive the machine
for the purpose of moving it to a different
location.
(a) Travel with the boom fully retracted and
the boom angle at less than horizontal.
(b) Travel with the travel speed select switch
set to “ ” (LOW SPEED).
(c) The machine may suddenly incline when
climbing up and over a top step. Pay
attention to buildings and structures
located above and below the platform.
M085K702
Fig. 1‒26
M085K802
Fig. 1‒27