Aichi SR12CSM, Руководство по эксплуатации с информацией по обслуживанию

Страница: 35 / 78

27
DANGER
If the pre-operation checks reveal any
abnormalities, immediately put an “Out
of Order” sign on the machine, and stop
using the machine.
The use of the machine not repaired can
cause a serious accident. After repairs are
completed, perform the pre-operation
checks again from the beginning.
WARNING
• Do not operate the machine before
performing pre-operation checks
described in this manual.
• Perform the pre-operation checks on firm,
level surface. Begin the checks with the
platform lowered.
• If there is damage, such as cracks, on the
welds of the platform guardrail, or on
the guardrail pipes, change the guardrail
immediately.
• If there is damage, such as cracks or
deformation, on the floor of the platform,
immediately contact AICHI or an AICHI
dealer for repairing.
• Make sure to perform the checks with no
load on the platform, because if there is a
load on the platform, the checks will not
be exact.
CAUTION
Damage and stains to the decals will
obstruct correct handling. Immediately
remove the stain, or change the decals.
NOTICE
Make a copy of the daily inspection check
sheet (at the end of this manual). Make
a check in the appropriate box on the
sheet while performing the pre-operation
checks.
1. Visual Check
Circle the machine once and check visually
that there are no oil leaks, and no damage
to the decals or to the machine. In winter or
cold climate, remove snow and ice from the
machine for safety before using the machine.
At the time, do not pour hot water to the
machine to melt snow and ice.
Check for cracks, or breaks in the boom,
platform, and other parts. Check for loose bolts,
and open covers. Check that all the guardrails
are attached properly. Make sure that all
compartment covers are in place and latched.
Check that all decals are in place, legible and
not damaged. Replace any missing or damaged
decals. Use mild soap and water to clean decals
if dirty. Refer to Section 2 of Chapter 2 for
decals and their locations.
Check the fuel, hydraulic oil, battery fluid,
engine oil, and coolant levels. (Refer to Chapter
7 for details)
Check that greasing points are lubricated
sufficiently.
Pre-operation Checks